Hi Claudiu, On Thu, Aug 21, 2025 at 11:03:30AM +0300, Claudiu wrote: > From: Claudiu Beznea <claudiu.beznea.uj@xxxxxxxxxxxxxx> > > Hi, > > This series disables clocks that remain unused after resume. > This is necessary when the resume process is done with the help of the > bootloader, as the bootloader enables various clocks when returning from > resume. > > On the RZ/G3S SoC (where this series was tested), the bootloader enables > the SDHI clocks (for all SDHI modules, of which 2 are used by Linux and > 1 is unused) and the clocks for a serial IP (unused by Linux). > > Testing was done on the RZ/G3S SMARC Carrier II board. Do you think that other boards would also benefit from this change? If so, what do you think about putting the call to register_pm_notifier() inside an __init block in clk.c so that this same change doesn't have to be implemented across various clk drivers? Alternatively, if this is board specific, could this be fixed in the boot loader so that the clock that's not used by Linus is properly shut down on resume? I'm not the subsystem maintainer, so I'm not asking you to make any of these changes. Brian
