Hi Geert, Thank you for the review. On Wed, Jul 2, 2025 at 2:19 PM Geert Uytterhoeven <geert@xxxxxxxxxxxxxx> wrote: > > Hi Prabhakar, > > On Fri, 27 Jun 2025 at 21:37, Prabhakar <prabhakar.csengg@xxxxxxxxx> wrote: > > From: Lad Prabhakar <prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx> > > > > Introduce device tree overlays for supporting the eMMC (RTK0EF0186B02000BJ) > > and microSD (RTK0EF0186B01000BJ) sub-boards connected via the CN15 > > connector on the RZ/V2H and RZ/V2N evaluation kits. > > > > These overlays enable SDHI0 with appropriate pin control settings, power > > regulators, and GPIO handling. Both sub-boards are supported using shared > > overlay files that can be applied to either EVK due to their identical > > connector layout and interface support. > > > > To support this, new DT overlay files are added: > > - `rzv2-evk-cn15-emmc.dtso` for eMMC > > - `rzv2-evk-cn15-sd.dtso` for microSD > > > > Additionally, the base DTS files for both EVKs are updated to include a > > fixed 1.8V regulator (`reg_1p8v`) needed by the eMMC sub-board and > > potential future use cases such as HDMI output. > > > > Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx> > > --- > > v1->v2: > > - Dropped patch 2/3 from previous series as that has been merged. > > - Dropped adding alias in base DTS instead added in overlay. > > - Switched to using single overlay files for both RZ/V2H and RZ/V2N EVKs > > instead of separate overlays for each EVK. > > - Used RZG2L_GPIO and RZG2L_PORT_PINMUX to avoid using SoC specific > > macros. > > Thanks for the update! > > > --- a/arch/arm64/boot/dts/renesas/Makefile > > +++ b/arch/arm64/boot/dts/renesas/Makefile > > @@ -161,8 +161,16 @@ r9a09g047e57-smarc-cru-csi-ov5645-dtbs := r9a09g047e57-smarc.dtb r9a09g047e57-sm > > dtb-$(CONFIG_ARCH_R9A09G047) += r9a09g047e57-smarc-cru-csi-ov5645.dtb > > > > dtb-$(CONFIG_ARCH_R9A09G056) += r9a09g056n48-rzv2n-evk.dtb > > +dtb-$(CONFIG_ARCH_R9A09G056) += rzv2-evk-cn15-emmc.dtbo > > +r9a09g056n48-rzv2-evk-cn15-emmc.dts := r9a09g056n48-rzv2n-evk.dtb rzv2-evk-cn15-emmc.dtbo > > .dts? > Ouch. > I take it you meant: > > +r9a09g056n48-rzv2n-evk-cn15-emmc-dtbs := > r9a09g056n48-rzv2n-evk.dtb rzv2-evk-cn15-emmc.dtbo > +dtb-$(CONFIG_ARCH_R9A09G056) += r9a09g056n48-rzv2n-evk-cn15-emmc.dtb > > > +dtb-$(CONFIG_ARCH_R9A09G056) += rzv2-evk-cn15-sd.dtbo > > +r9a09g056n48-rzv2-evk-cn15-sd.dts := r9a09g056n48-rzv2n-evk.dtb rzv2-evk-cn15-sd.dtbo > > +r9a09g056n48-rzv2n-evk-cn15-sd-dtbs := r9a09g056n48-rzv2n-evk.dtb > rzv2-evk-cn15-sd.dtbo > +dtb-$(CONFIG_ARCH_R9A09G056) += r9a09g056n48-rzv2n-evk-cn15-sd.dtb > > > dtb-$(CONFIG_ARCH_R9A09G057) += r9a09g057h44-rzv2h-evk.dtb > > +dtb-$(CONFIG_ARCH_R9A09G057) += rzv2-evk-cn15-emmc.dtbo > > +r9a09g057h44-rzv2-evk-cn15-emmc.dts := r9a09g057h44-rzv2h-evk.dtb rzv2-evk-cn15-emmc.dtbo > > +r9a09g057h44-rzv2h-evk-cn15-emmc-dtbs := > r9a09g057h44-rzv2h-evk.dtb rzv2-evk-cn15-emmc.dtbo > +dtb-$(CONFIG_ARCH_R9A09G057) += r9a09g057h44-rzv2h-evk-cn15-emmc.dtb > > > +dtb-$(CONFIG_ARCH_R9A09G057) += rzv2-evk-cn15-sd.dtbo > > +r9a09g057h44-rzv2-evk-cn15-sd.dts := r9a09g057h44-rzv2h-evk.dtb rzv2-evk-cn15-sd.dtbo > > +r9a09g057h44-rzv2h-evk-cn15-sd-dtbs := r9a09g057h44-rzv2h-evk.dtb > rzv2-evk-cn15-sd.dtbo > +dtb-$(CONFIG_ARCH_R9A09G057) += r9a09g057h44-rzv2h-evk-cn15-sd.dtb > > > dtb-$(CONFIG_ARCH_R9A09G057) += r9a09g057h48-kakip.dtb > > > > dtb-$(CONFIG_ARCH_RCAR_GEN3) += draak-ebisu-panel-aa104xd12.dtbo > > Reviewed-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx> > i.e. will queue in renesas-devel for v6.17, with the above fixed. > Thank you for taking care of it. Cheers, Prabhakar
