On Sat, May 31, 2025 at 12:53:21AM +0200, Marek Vasut wrote: > The V4H Sparrow Hawk board supplies PCIe controller input clock and PCIe > bus clock from separate outputs of Renesas 9FGV0441 clock generator chip. > Describe this split bus configuration in the board DT. The topology looks > as follows: > > ____________ _____________ > | R-Car PCIe | | PCIe device | > | | | | > | PCIe RX<|==================|>PCIe TX | > | PCIe TX<|==================|>PCIe RX | > | | | | > | PCIe CLK<|======.. ..======|>PCIe CLK | > '------------' || || '-------------' > || || > ____________ || || > | 9FGV0441 | || || > | | || || > | CLK DIF0<|======'' || > | CLK DIF1<|=========='' > | CLK DIF2<| > | CLK DIF3<| > '------------' > > Signed-off-by: Marek Vasut <marek.vasut+renesas@xxxxxxxxxxx> Acked-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx> - Mani > --- > Cc: Bartosz Golaszewski <brgl@xxxxxxxx> > Cc: Bjorn Helgaas <bhelgaas@xxxxxxxxxx> > Cc: Conor Dooley <conor+dt@xxxxxxxxxx> > Cc: Geert Uytterhoeven <geert+renesas@xxxxxxxxx> > Cc: Krzysztof Kozlowski <krzk+dt@xxxxxxxxxx> > Cc: Magnus Damm <magnus.damm@xxxxxxxxx> > Cc: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx> > Cc: Rob Herring <robh@xxxxxxxxxx> > Cc: Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx> > Cc: devicetree@xxxxxxxxxxxxxxx > Cc: linux-kernel@xxxxxxxxxxxxxxx > Cc: linux-pci@xxxxxxxxxxxxxxx > Cc: linux-renesas-soc@xxxxxxxxxxxxxxx > --- > V2: Use pciec0_rp/pciec1_rp phandles to refer to root port moved to core r8a779g0.dtsi > --- > .../dts/renesas/r8a779g3-sparrow-hawk.dts | 31 +++++++++++++++++-- > 1 file changed, 29 insertions(+), 2 deletions(-) > > diff --git a/arch/arm64/boot/dts/renesas/r8a779g3-sparrow-hawk.dts b/arch/arm64/boot/dts/renesas/r8a779g3-sparrow-hawk.dts > index b8698e07add56..9ba23129e65ec 100644 > --- a/arch/arm64/boot/dts/renesas/r8a779g3-sparrow-hawk.dts > +++ b/arch/arm64/boot/dts/renesas/r8a779g3-sparrow-hawk.dts > @@ -130,6 +130,13 @@ mini_dp_con_in: endpoint { > }; > }; > > + /* Page 26 / PCIe.0/1 CLK */ > + pcie_refclk: clk-x8 { > + compatible = "fixed-clock"; > + #clock-cells = <0>; > + clock-frequency = <25000000>; > + }; > + > reg_1p2v: regulator-1p2v { > compatible = "regulator-fixed"; > regulator-name = "fixed-1.2V"; > @@ -404,6 +411,14 @@ i2c0_mux2: i2c@2 { > reg = <2>; > #address-cells = <1>; > #size-cells = <0>; > + > + /* Page 26 / PCIe.0/1 CLK */ > + pcie_clk: clk@68 { > + compatible = "renesas,9fgv0441"; > + reg = <0x68>; > + clocks = <&pcie_refclk>; > + #clock-cells = <1>; > + }; > }; > > i2c0_mux3: i2c@3 { > @@ -487,26 +502,38 @@ msiof1_snd_endpoint: endpoint { > > /* Page 26 / 2230 Key M M.2 */ > &pcie0_clkref { > - clock-frequency = <100000000>; > + status = "disabled"; > }; > > &pciec0 { > + clocks = <&cpg CPG_MOD 624>, <&pcie_clk 0>; > reset-gpios = <&gpio2 2 GPIO_ACTIVE_LOW>; > status = "okay"; > }; > > +&pciec0_rp { > + clocks = <&pcie_clk 1>; > + vpcie3v3-supply = <®_3p3v>; > +}; > + > /* Page 25 / PCIe to USB */ > &pcie1_clkref { > - clock-frequency = <100000000>; > + status = "disabled"; > }; > > &pciec1 { > + clocks = <&cpg CPG_MOD 625>, <&pcie_clk 2>; > /* uPD720201 is PCIe Gen2 x1 device */ > num-lanes = <1>; > reset-gpios = <&gpio2 0 GPIO_ACTIVE_LOW>; > status = "okay"; > }; > > +&pciec1_rp { > + clocks = <&pcie_clk 3>; > + vpcie3v3-supply = <®_3p3v>; > +}; > + > &pfc { > pinctrl-0 = <&scif_clk_pins>; > pinctrl-names = "default"; > -- > 2.47.2 > -- மணிவண்ணன் சதாசிவம்