This is needed for AP mode. Otherwise client sees the network, but can't connect to it. REG_FWHW_TXQ_CTRL+1 is set to WLAN_TXQ_RPT_EN (0x1F) in common mac init function (__rtw8723x_mac_init), but the value was overwritten from mac table later. mac_postinit is run after registers from mac table are set, this allows to set correct values. Tested on rtl8723cs, that reuses rtw8703b driver. Changes in v2: - introduce mac_postinit callback to avoid changing register tables Andrey Skvortsov (2): wifi: rtw88: introduce callback to override phy parameters from tables wifi: rtw88: enable TX reports for the management queue drivers/net/wireless/realtek/rtw88/mac.c | 11 +++++++++++ drivers/net/wireless/realtek/rtw88/mac.h | 1 + drivers/net/wireless/realtek/rtw88/main.c | 6 ++++++ drivers/net/wireless/realtek/rtw88/main.h | 1 + drivers/net/wireless/realtek/rtw88/rtw8703b.c | 1 + drivers/net/wireless/realtek/rtw88/rtw8723d.c | 1 + drivers/net/wireless/realtek/rtw88/rtw8723x.c | 9 ++++++++- drivers/net/wireless/realtek/rtw88/rtw8723x.h | 6 ++++++ 8 files changed, 35 insertions(+), 1 deletion(-) -- 2.47.2
