On 6/6/2025 4:53 PM, Hariharan Basuthkar wrote:
The power value is 6 dBm on an AP operating on the 6 GHz channel. This is a very low value. On 6 GHz, the target computes the EIRP based on the power values sent in the WMI_VDEV_SET_TPC_POWER_CMD. Currently, this is being sent only for station interfaces and not for AP interfaces. Therefore, add AP vdev to the condition in ath12k_mac_station_supports_tpc() and rename ath12k_mac_station_supports_tpc() to ath12k_mac_supports_tpc(). For a AP vdev, hardcode ap_power_type as IEEE80211_REG_LPI_AP, which is filled in the WMI_VDEV_SET_TPC_POWER_CMDID sent to the target. Currently, LPI is the only supported AP power mode. Since there is no method currently to set the AP power mode from user-space, the power mode is hard-coded to LPI. Retain the existing logic for populating the power mode for a station vdev. Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.4.1-00199-QCAHKSWPL_SILICONZ-1 Signed-off-by: Hariharan Basuthkar <quic_hbasuthk@xxxxxxxxxxx>
Reviewed-by: Vasanthakumar Thiagarajan <vasanthakumar.thiagarajan@xxxxxxxxxxxxxxxx>
