On 6/3/2025 12:05 PM, Sarika Sharma wrote:
When both AP/STA and monitor interfaces are enabled, ieee80211_tx_status() is invoked from two paths: the TX completion handler for data frames and the WMI TX completion handler for management frames. In the data path, the skb->cb is properly zeroed using memset, but in the WMI path, this step is missing. As a result, mac80211 encountered uninitialized (junk) values in skb->cb when generating the radiotap header for monitor mode, leading to invalid radiotap lengths. Hence, explicitly zero the status field in the skb->cb using memset in WMI TX completion path to ensure consistent and correct behavior during WMI tx completion path. Additionally, set info->status.rates[0].idx = -1 to indicate that no valid rate information is available, avoiding misinterpretation of garbage values. Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.4.1-00199-QCAHKSWPL_SILICONZ-1 Signed-off-by: Sarika Sharma <quic_sarishar@xxxxxxxxxxx>
Reviewed-by: Vasanthakumar Thiagarajan <vasanthakumar.thiagarajan@xxxxxxxxxxxxxxxx>
