From: Kurt Lee <kurt.lee@xxxxxxxxxxx>
wpa_supplicant sends NL80211_CMD_GET_SURVEY command every time after
normal scan, which causes brcmfmac surveying each channel again.
Currently brcmfmac implments brcmf_cfg80211_dump_survey focusing on AP
mode, thus this change will return the request other than AP mode.
Signed-off-by: Kurt Lee <kurt.lee@xxxxxxxxxxx>
Signed-off-by: Ian Lin <ian.lin@xxxxxxxxxxxx>
---
drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c | 3 +++
1 file changed, 3 insertions(+)
diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c
index 820dc5fee730..e23cd6fc0f56 100644
--- a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c
+++ b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c
@@ -8122,6 +8122,9 @@ brcmf_cfg80211_dump_survey(struct wiphy *wiphy, struct net_device *ndev,
brcmf_dbg(TRACE, "Enter: channel idx=%d\n", idx);
+ if (!brcmf_is_apmode(ifp->vif))
+ return -ENOENT;
+
/* Do not run survey when VIF in CONNECTING / CONNECTED states */
if ((test_bit(BRCMF_VIF_STATUS_CONNECTING, &ifp->vif->sme_state)) ||
(test_bit(BRCMF_VIF_STATUS_CONNECTED, &ifp->vif->sme_state))) {
--
2.25.0
