From: Ting-Ying Li <tingying.li@xxxxxxxxxxx>
Fmac need to update "chanspec" iovar for each SoftAP creation
because firmware will update the chanspec to current bsscfg
for each bss. If it doesn't update then the wrong chanspec
will be shown on the result of 'wl -i [interface] status'
command. No need to handle channel resource reusing for mbss
mode by the host driver, it should be covered by firmware.
Signed-off-by: Ting-Ying Li <tingying.li@xxxxxxxxxxx>
Signed-off-by: Ian Lin <ian.lin@xxxxxxxxxxxx>
---
.../broadcom/brcm80211/brcmfmac/cfg80211.c | 20 +++++++++----------
1 file changed, 10 insertions(+), 10 deletions(-)
diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c
index 2e06fd0dbb2a..820dc5fee730 100644
--- a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c
+++ b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c
@@ -5248,17 +5248,17 @@ brcmf_cfg80211_start_ap(struct wiphy *wiphy, struct net_device *ndev,
err);
goto exit;
}
- if (!mbss) {
- /* Firmware 10.x requires setting channel after enabling
- * AP and before bringing interface up.
- */
- err = brcmf_fil_iovar_int_set(ifp, "chanspec", chanspec);
- if (err < 0) {
- bphy_err(drvr, "Set Channel failed: chspec=%d, %d\n",
- chanspec, err);
- goto exit;
- }
+
+ /* Firmware 10.x requires setting channel after enabling
+ * AP and before bringing interface up.
+ */
+ err = brcmf_fil_iovar_int_set(ifp, "chanspec", chanspec);
+ if (err < 0) {
+ bphy_err(drvr, "Set Channel failed: chspec=%d, %d\n",
+ chanspec, err);
+ goto exit;
}
+
err = brcmf_fil_cmd_int_set(ifp, BRCMF_C_UP, 1);
if (err < 0) {
bphy_err(drvr, "BRCMF_C_UP error (%d)\n", err);
--
2.25.0
