Hi Hugo, > -----Original Message----- > From: Hugo Villeneuve <hugo@xxxxxxxxxxx> > Sent: 22 May 2025 20:14 > Subject: Re: [PATCH v3 0/2] drm: rcar-du: rzg2l_mipi_dsi: add MIPI DSI command support > > On Thu, 22 May 2025 18:40:29 +0000 > Biju Das <biju.das.jz@xxxxxxxxxxxxxx> wrote: > > > Hi Hugo, > > > > Thanks for the patch. > > > > > -----Original Message----- > > > From: Hugo Villeneuve <hugo@xxxxxxxxxxx> > > > Sent: 22 May 2025 15:39 > > > Subject: [PATCH v3 0/2] drm: rcar-du: rzg2l_mipi_dsi: add MIPI DSI > > > command support > > > > > > From: Hugo Villeneuve <hvilleneuve@xxxxxxxxxxxx> > > > > > > Hello, > > > this patch series add support for sending MIPI DSI command packets > > > to the Renesas RZ/G2L MIPI DSI driver. > > > > > > Tested on a custom board with a SolidRun RZ/G2L SOM, with two > > > different LCD panels using the jd9365da and st7703 drivers. > > > > > > Tested short and long writes. > > > > > > Tested read of 1 byte, 2 bytes and long reads. > > > > I see tested-by tag for patch[1] and this patch series is conflict with that patch. > > Hi Biju, > there is no conflict per se for the moment, as these are two separate submissions. Chris's patch is > not part of this submission. > > I tested patch[1] by rebasing my series on top of Chris patch. > > > Can this patch series work without patch[1]? If yes, no issue. > > Yes it can. > > > > Otherwise, you need to rebase your patch on top of [1] to avoid merge conflict. > > Eventually, if Chris's patch is accepted before my series, I will rebase and resubmit then. Right now, > it seems I cannot do it, because submitting my serie based on an "not yet accepted" patch will result > in the kernel test robot complaining (and rightly so). Unless there is a mean to specify that my serie > depends on other unapplied patch... > > Ideally, it should have been easier if I could have integrated Chris's patch into my serie, but he > preferred to send his patch alone since he felt that it could be accepted more rapidly like this. OK, I have added your patch + Chris's patch and tested with ADV7535 connected to display. But the display is unstable. I need to figure out which patch is causing the issue. Cheers, Biju
