On Tue, Apr 08, 2025 at 08:30:56AM +0200, Wolfram Sang wrote:
> The Renesas RZ/N1-extension board also connects only two out of three
> LED outputs from the Marvell PHY to the actual LEDs. The already
> existing setting MARVELL_PHY_LED0_LINK_LED1_ACTIVE fits this scenario,
> but a device flag cannot be used because the PHYs use a generic MDIO bus
> on which also PHYs from other vendors reside. So, the driver is updated
> to count the number of LED nodes in DT. If the number is 2, the
> alternative LED configuration is used, otherwise the default one.
>
> Signed-off-by: Wolfram Sang <wsa+renesas@xxxxxxxxxxxxxxxxxxxx>
Hi Wolfram
Please make use of the LED binding:
&mdio {
pinctrl-0 = <&mdio_pins>;
pinctrl-names = "default";
phy0: ethernet-phy@0 {
reg = <0>;
leds {
#address-cells = <1>;
#size-cells = <0>;
led@0 {
reg = <0>;
color = <LED_COLOR_ID_WHITE>;
function = LED_FUNCTION_WAN;
default-state = "keep";
};
};
};
Just list the two LEDs you have connected.
Andrew
