Hi, Wolfram,
On 07.08.2025 18:14, Wolfram Sang wrote:
> Enable I3C on the dedicated connector of the RZ/G3S module. Provide
> safe defaults allowing to connect even to slow I2C devices.
>
> Signed-off-by: Wolfram Sang <wsa+renesas@xxxxxxxxxxxxxxxxxxxx>
> ---
> arch/arm64/boot/dts/renesas/rzg3s-smarc-som.dtsi | 7 +++++++
> 1 file changed, 7 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/renesas/rzg3s-smarc-som.dtsi b/arch/arm64/boot/dts/renesas/rzg3s-smarc-som.dtsi
> index 39845faec894..17fd30df3432 100644
> --- a/arch/arm64/boot/dts/renesas/rzg3s-smarc-som.dtsi
> +++ b/arch/arm64/boot/dts/renesas/rzg3s-smarc-som.dtsi
> @@ -7,6 +7,7 @@
>
> #include <dt-bindings/clock/renesas,r9a08g045-vbattb.h>
> #include <dt-bindings/gpio/gpio.h>
> +#include <dt-bindings/i3c/i3c.h>
> #include <dt-bindings/pinctrl/rzg2l-pinctrl.h>
>
> #include "rzg3s-smarc-switches.h"
> @@ -172,6 +173,12 @@ a0 80 30 30 9c
> };
> };
>
> +&i3c {
> + i2c-scl-hz = <100000>;
> + i3c-scl-hz = <12500000>;
I'm not familiar with I3C but from the HW manual it seems there is some
level of control for I3C in pin controller:
- on Input Enable Control Register (IEN_m) there is this note: Note 1. 1b:
applies to terminals of TMS_SWDIO, I3C_SCL, I3C_SDA, P1_0, P7_0
- there is I3C_SET register (bit POC) which controls the I3C voltage, so, I
presume, depending on the SW_I3C_VIO_SEL switch on the board (which
selects the output of VDD_I3C regulator) the pins would have to be
configured with proper power-source = <1800> or power-source = <1200>
Thank you,
Claudiu
> + status = "okay";
> +};
> +
> #if SW_CONFIG2 == SW_ON
> /* SD0 slot */
> &sdhi0 {
