The Retronix R-Car V4H Sparrow Hawk EVTB1 uses 1V8 IO voltage supply
for VDDQ18_25_AVB power rail. Update the AVB0 pinmux to reflect the
change in IO voltage. Since the VDDQ18_25_AVB power rail is shared,
all four AVB0, AVB1, AVB2, TSN0 PFC/GPIO POC[7..4] registers have to
be configured the same way. As the EVTA1 boards are from a limited run
and generally not available, update the DT to make it compatible with
EVTB1 IO voltage settings.
Fixes: a719915e76f2 ("arm64: dts: renesas: r8a779g3: Add Retronix R-Car V4H Sparrow Hawk board support")
Signed-off-by: Marek Vasut <marek.vasut+renesas@xxxxxxxxxxx>
---
Cc: Conor Dooley <conor+dt@xxxxxxxxxx>
Cc: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
Cc: Krzysztof Kozlowski <krzk+dt@xxxxxxxxxx>
Cc: Magnus Damm <magnus.damm@xxxxxxxxx>
Cc: Rob Herring <robh@xxxxxxxxxx>
Cc: devicetree@xxxxxxxxxxxxxxx
Cc: linux-renesas-soc@xxxxxxxxxxxxxxx
---
arch/arm64/boot/dts/renesas/r8a779g3-sparrow-hawk.dts | 4 ++++
1 file changed, 4 insertions(+)
diff --git a/arch/arm64/boot/dts/renesas/r8a779g3-sparrow-hawk.dts b/arch/arm64/boot/dts/renesas/r8a779g3-sparrow-hawk.dts
index 89c61ba0e206..f4f845801ac9 100644
--- a/arch/arm64/boot/dts/renesas/r8a779g3-sparrow-hawk.dts
+++ b/arch/arm64/boot/dts/renesas/r8a779g3-sparrow-hawk.dts
@@ -608,6 +608,10 @@ pins-mii {
drive-strength = <21>;
};
+ pins-vddq18-25-avb {
+ pins = "PIN_VDDQ_AVB0", "PIN_VDDQ_AVB1", "PIN_VDDQ_AVB2", "PIN_VDDQ_TSN0";
+ power-source = <1800>;
+ };
};
/* Page 28 / CANFD_IF */
--
2.47.2
