Dear ValdikSS,
Thank you for your patch. Please make sure to use `git format-patch
-v<N>` (reroll count) to mark the iteration of the patch.
Am 27.07.25 um 22:43 schrieb ValdikSS:
Device ID comparison in igc_is_device_id_i226 is performed before
the ID is set, resulting in always failing check on init.
Before the patch:
* L1.2 is not disabled on init
* L1.2 is properly disabled after suspend-resume cycle
With the patch:
* L1.2 is properly disabled both on init and after suspend-resume
How to test:
Connect to the 1G link with 300+ mbit/s Internet speed, and run
the download speed test, such as:
curl -o /dev/null http://speedtest.selectel.ru/1GB
Without L1.2 disabled, the speed would be no more than ~200 mbit/s.
With L1.2 disabled, the speed would reach 1 gbit/s.
Note: it's required that the latency between your host and the remote
be around 3-5 ms, the test inside LAN (<1 ms latency) won't trigger the
issue.
`sudo lspci -vv -s <x>` can be used to check L1.2 enablement under
`L1SubCtl1`.
Link: https://lore.kernel.org/intel-wired-lan/15248b4f-3271-42dd-8e35-02bfc92b25e1@xxxxxxxxx
Fixes: 0325143b59c6 ("igc: disable L1.2 PCI-E link substate to avoid performance issue")
Signed-off-by: ValdikSS <iam@xxxxxxxxxxxxxxx>
Reviewed-by: Vitaly Lifshits <vitaly.lifshits@xxxxxxxxx>
---
drivers/net/ethernet/intel/igc/igc_main.c | 14 +++++++-------
1 file changed, 7 insertions(+), 7 deletions(-)
diff --git a/drivers/net/ethernet/intel/igc/igc_main.c b/drivers/net/ethernet/intel/igc/igc_main.c
index 031c332f6..1b4465d6b 100644
--- a/drivers/net/ethernet/intel/igc/igc_main.c
+++ b/drivers/net/ethernet/intel/igc/igc_main.c
@@ -7115,6 +7115,13 @@ static int igc_probe(struct pci_dev *pdev,
adapter->port_num = hw->bus.func;
adapter->msg_enable = netif_msg_init(debug, DEFAULT_MSG_ENABLE);
+ /* PCI config space info */
+ hw->vendor_id = pdev->vendor;
+ hw->device_id = pdev->device;
+ hw->revision_id = pdev->revision;
+ hw->subsystem_vendor_id = pdev->subsystem_vendor;
+ hw->subsystem_device_id = pdev->subsystem_device;
+
/* Disable ASPM L1.2 on I226 devices to avoid packet loss */
if (igc_is_device_id_i226(hw))
pci_disable_link_state(pdev, PCIE_LINK_STATE_L1_2);
@@ -7141,13 +7148,6 @@ static int igc_probe(struct pci_dev *pdev,
netdev->mem_start = pci_resource_start(pdev, 0);
netdev->mem_end = pci_resource_end(pdev, 0);
- /* PCI config space info */
- hw->vendor_id = pdev->vendor;
- hw->device_id = pdev->device;
- hw->revision_id = pdev->revision;
- hw->subsystem_vendor_id = pdev->subsystem_vendor;
- hw->subsystem_device_id = pdev->subsystem_device;
-
/* Copy the default MAC and PHY function pointers */
memcpy(&hw->mac.ops, ei->mac_ops, sizeof(hw->mac.ops));
memcpy(&hw->phy.ops, ei->phy_ops, sizeof(hw->phy.ops));
Reviewed-by: Paul Menzel <pmenzel@xxxxxxxxxxxxx>
Kind regards,
Paul
