There are many places we agreed to move the wake and perst gpio's and phy etc to the pcie root port node instead of bridge node[1]. So move the phy, phy-names, wake-gpio's in the root port. There is already reset-gpio defined for PERST# in pci-bus-common.yaml, start using that property instead of perst-gpio. For backward compatibility, not removing any existing properties in the bridge node. There are some other properties like num-lanes, max-link-speed which needs to be moved to the root port nodes, but in this series we are excluding them for now as this requires more changes in dwc layer and can complicate the things. The main intention of this series is to move wake# to the root port node. After this series we wil come up with a patch which regiters for wake IRQ from the pcieport driver. The wake IRQ is needed for the endpoint to wakeup the host from D3cold. [1] https://lore.kernel.org/linux-pci/20241211192014.GA3302752@bhelgaas/ Signed-off-by: Krishna Chaitanya Chundru <krishna.chundru@xxxxxxxxxxxxxxxx> --- Changes in v2: - Remove phy-names property and change the driver, dtsi accordingly (Rob) - Link to v1: https://lore.kernel.org/r/20250322-perst-v1-0-e5e4da74a204@xxxxxxxxxxxxxxxx --- Krishna Chaitanya Chundru (3): dt-bindings: PCI: qcom: Move phy, wake & reset gpio's to root port arm64: qcom: sc7280: Move phy, perst to root port node PCI: qcom: Add support for multi-root port .../devicetree/bindings/pci/qcom,pcie-common.yaml | 18 +++ .../devicetree/bindings/pci/qcom,pcie-sc7280.yaml | 17 ++- arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts | 5 +- arch/arm64/boot/dts/qcom/sc7280-herobrine.dtsi | 5 +- arch/arm64/boot/dts/qcom/sc7280-idp.dtsi | 5 +- arch/arm64/boot/dts/qcom/sc7280.dtsi | 6 +- drivers/pci/controller/dwc/pcie-qcom.c | 149 +++++++++++++++++---- 7 files changed, 168 insertions(+), 37 deletions(-) --- base-commit: 8ffd015db85fea3e15a77027fda6c02ced4d2444 change-id: 20250101-perst-cb885b5a6129 Best regards, -- Krishna Chaitanya Chundru <krishna.chundru@xxxxxxxxxxxxxxxx>
