在 2025/7/28 12:21, Heming Zhao 写道:
Commit a1fd37f97808 ("md: Don't wait for MD_RECOVERY_NEEDED for
HOT_REMOVE_DISK ioctl") introduced a regression in the md_cluster
module. (Failed cases 02r1_Manage_re-add & 02r10_Manage_re-add)
Consider a 2-node cluster:
- node1 set faulty & remove command on a disk.
- node2 must correctly update the array metadata.
Before a1fd37f97808, on node1, the delay between msg:METADATA_UPDATED
(triggered by faulty) and msg:REMOVE was sufficient for node2 to
reload the disk info (written by node1).
After a1fd37f97808, node1 no longer waits between faulty and remove,
causing it to send msg:REMOVE while node2 is still reloading disk info.
This often results in node2 failing to remove the faulty disk.
== how to trigger ==
set up a 2-node cluster (node1 & node2) with disks vdc & vdd.
on node1:
mdadm -CR /dev/md0 -l1 -b clustered -n2 /dev/vdc /dev/vdd --assume-clean
ssh node2-ip mdadm -A /dev/md0 /dev/vdc /dev/vdd
mdadm --manage /dev/md0 --fail /dev/vdc --remove /dev/vdc
check array status on both nodes with "mdadm -D /dev/md0".
node1 output:
Number Major Minor RaidDevice State
- 0 0 0 removed
1 254 48 1 active sync /dev/vdd
node2 output:
Number Major Minor RaidDevice State
- 0 0 0 removed
1 254 48 1 active sync /dev/vdd
0 254 32 - faulty /dev/vdc
Fixes: a1fd37f97808 ("md: Don't wait for MD_RECOVERY_NEEDED for HOT_REMOVE_DISK ioctl")
Signed-off-by: Heming Zhao<heming.zhao@xxxxxxxx>
---
drivers/md/md.c | 9 ++++++---
1 file changed, 6 insertions(+), 3 deletions(-)
Applied to md-6.17
Thanks
