On 8/17/2025 11:41 AM, Arend van Spriel wrote:
From: Wright Feng <wright.feng@xxxxxxxxxxx>
hostapd & wpa_supplicant userspace daemons exposes an AP mode specific
config file parameter "ap_isolate" to the user, which is used to control
low-level bridging of frames between the stations associated in the BSS.
In driver, handle this user setting in the newly defined cfg80211_ops
function brcmf_cfg80211_change_bss() by enabling "ap_isolate" IOVAR in
the firmware.
In AP mode, the "ap_isolate" value from the cfg80211 layer represents,
0 = allow low-level bridging of frames between associated stations
1 = restrict low-level bridging of frames to isolate associated stations
-1 = do not change existing setting
Hi Johannes,
See that auto-delegation in Patchwork is working, but if you don't mind
I bounce this one back to you as I feel being a bit too involved in this
one.
Regards,
Arend
Signed-off-by: Wright Feng <wright.feng@xxxxxxxxxxx>
Signed-off-by: Chi-hsien Lin <chi-hsien.lin@xxxxxxxxxxx>
Signed-off-by: Gokul Sivakumar <gokulkumar.sivakumar@xxxxxxxxxxxx>
[arend: indicate ap_isolate support in struct wiphy::bss_param_support]
Signed-off-by: Arend van Spriel <arend.vanspriel@xxxxxxxxxxxx>
---
.../broadcom/brcm80211/brcmfmac/cfg80211.c | 24 +++++++++++++++++++
1 file changed, 24 insertions(+)
