Enable 160MHz beamformee support on mt7922 by updating HE capability
element configuration. Previously, only 160MHz channel width was set,
but beamformee for 160MHz was not properly advertised. This patch
adds BEAMFORMEE_MAX_STS_ABOVE_80MHZ_4 capability to allow devices
to utilize 160MHz BW for beamforming.
Tested by connecting to 160MHz-bandwidth beamforming AP and verified
HE capability.
Signed-off-by: Quan Zhou <quan.zhou@xxxxxxxxxxxx>
---
drivers/net/wireless/mediatek/mt76/mt7921/main.c | 2 ++
1 file changed, 2 insertions(+)
diff --git a/drivers/net/wireless/mediatek/mt76/mt7921/main.c b/drivers/net/wireless/mediatek/mt76/mt7921/main.c
index 40954e64c7fc..8818fb1916ad 100644
--- a/drivers/net/wireless/mediatek/mt76/mt7921/main.c
+++ b/drivers/net/wireless/mediatek/mt76/mt7921/main.c
@@ -135,6 +135,8 @@ mt7921_init_he_caps(struct mt792x_phy *phy, enum nl80211_band band,
if (is_mt7922(phy->mt76->dev)) {
he_cap_elem->phy_cap_info[0] |=
IEEE80211_HE_PHY_CAP0_CHANNEL_WIDTH_SET_160MHZ_IN_5G;
+ he_cap_elem->phy_cap_info[4] |=
+ IEEE80211_HE_PHY_CAP4_BEAMFORMEE_MAX_STS_ABOVE_80MHZ_4;
he_cap_elem->phy_cap_info[8] |=
IEEE80211_HE_PHY_CAP8_20MHZ_IN_160MHZ_HE_PPDU |
IEEE80211_HE_PHY_CAP8_80MHZ_IN_160MHZ_HE_PPDU;
--
2.46.0
