On 7/11/2025 2:47 PM, Roopni Devanathan wrote:
From: Sriram R <quic_srirrama@xxxxxxxxxxx> A multi-link client can use any link for transmissions. It can decide to put one link in power save mode for longer periods while listening on the other links as per MLD listen interval. Unicast management frames sent to that link station might get dropped if that link station is in power save mode or inactive. In such cases, firmware can take decision on which link to use. Allow the firmware to decide on which link management frame should be sent on, by filling the hardware link with maximum value of u32, so that the firmware will not have a specific link to transmit data on and so the management frames will be link agnostic. For QCN devices, all action frames are marked as link agnostic. For WCN devices, if the device is configured as an AP, then all frames other than probe response frames, authentication frames, association response frames, re-association response frames and ADDBA response frames are marked as link agnostic and if the device is configured as a station, then all frames other than probe request frames, authentication frames, de-authentication frames and ADDBA response frames are marked as link agnostic. Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.4.1-00199-QCAHKSWPL_SILICONZ-1 Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3 Signed-off-by: Sriram R <quic_srirrama@xxxxxxxxxxx> Co-developed-by: Roopni Devanathan <quic_rdevanat@xxxxxxxxxxx> Signed-off-by: Roopni Devanathan <quic_rdevanat@xxxxxxxxxxx>
Reviewed-by: Vasanthakumar Thiagarajan <vasanthakumar.thiagarajan@xxxxxxxxxxxxxxxx>
