On 6/4/2025 3:46 PM, Karthikeyan Kathirvel wrote:
Install beacon protection keys in hardware for AP modes only if hardware supports it, as indicated by the WMI service bit WMI_TLV_SERVICE_BEACON_PROTECTION_SUPPORT. Allow keyidx up to 7, since beacon protection uses keyidx 6 and 7. Control this feature by setting bit 0 of feature_enable_bitmap when sending the WMI_BCN_TMPL_CMDID command to firmware. Check for the beacon protection enabled bit in both tx and non-tx profiles for MBSSID cases. If set in either profile, enable the beacon protection feature in firmware for transmitted vif. Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.4.1-00199-QCAHKSWPL_SILICONZ-1 Signed-off-by: Karthikeyan Kathirvel <karthikeyan.kathirvel@xxxxxxxxxxxxxxxx>
Reviewed-by: Vasanthakumar Thiagarajan <vasanthakumar.thiagarajan@xxxxxxxxxxxxxxxx>
