On 4/30/2025 8:42 AM, Rajat Soni wrote: > From: Aishwarya R <quic_aisr@xxxxxxxxxxx> > > Whenever there is a change in the country code settings from the > user, driver does an intersection of the regulatory rules for this > new country with the original regulatory rules which were reported > during initialization time. > > There is also similar logic running in firmware with a difference > that the intersection in firmware is only done when the country code > is configuration during boot up time (BDF/OTP). Firmware logic does > not kick in when no country code is configured during device bring > up time as the device is always expected to have the country code > configured properly in the deployment. > > There is a debug/test use case that requires absolute regulatory > rules to be used for a user configured country code when the device > is not configured with a particular country code during boot up time. > > To support the above test use case, remove the redundant regulatory > rules intersection logic in the host driver. Depend on the > intersection logic in firmware when the device comes up with > pre-configured country code. > > Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.3.1-00209-QCAHKSWPL_SILICONZ-1 > Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3 > > Signed-off-by: Aishwarya R <quic_aisr@xxxxxxxxxxx> > Signed-off-by: Rajat Soni <quic_rajson@xxxxxxxxxxx> > --- > drivers/net/wireless/ath/ath12k/reg.c | 164 ++------------------------ > drivers/net/wireless/ath/ath12k/reg.h | 3 +- > drivers/net/wireless/ath/ath12k/wmi.c | 24 +--- > 3 files changed, 14 insertions(+), 177 deletions(-) While this applies cleanly on top of ath-next, it does not apply cleanly on the pending branch. Can you please rebase on ath/main-pending, and post a v2 with ath-pending as the destination branch tag? Don't worry if the patchwork bot ignores it due to an unknown branch tag. /jeff
