On Thu, 20 Mar 2025 16:54:26 +0530, Roopni Devanathan wrote:
> Before firmware assert, if there is a station interface in the device
> which is not associated with an AP, the basic rates are set to zero.
> Following this, during firmware recovery, when basic rates are zero,
> ath12k driver is sending invalid rate codes, which are negative values,
> to firmware. This results in firmware assert.
>
> Fix this by checking if rate codes are valid, before sending them
> to the firmware.
>
> [...]
Applied, thanks!
[1/1] wifi: ath12k: Fix incorrect rates sent to firmware
commit: cb1790249361ba9396b06b1af2500147e6e42e5e
Best regards,
--
Jeff Johnson <jeff.johnson@xxxxxxxxxxxxxxxx>
