irq_domain_add_linear() is going away as being obsolete now. Switch to
the preferred irq_domain_create_linear(). That differs in the first
parameter: It takes more generic struct fwnode_handle instead of struct
device_node. Therefore, of_fwnode_handle() is added around the
parameter.
Note some of the users can likely use dev->fwnode directly instead of
indirect of_fwnode_handle(dev->of_node). But dev->fwnode is not
guaranteed to be set for all, so this has to be investigated on case to
case basis (by people who can actually test with the HW).
Signed-off-by: Jiri Slaby (SUSE) <jirislaby@xxxxxxxxxx>
Cc: Michael Buesch <m@xxxxxxx>
Cc: linux-wireless@xxxxxxxxxxxxxxx
---
drivers/ssb/driver_gpio.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/ssb/driver_gpio.c b/drivers/ssb/driver_gpio.c
index 897cb8db5084..f9426a586653 100644
--- a/drivers/ssb/driver_gpio.c
+++ b/drivers/ssb/driver_gpio.c
@@ -148,8 +148,8 @@ static int ssb_gpio_irq_chipco_domain_init(struct ssb_bus *bus)
if (bus->bustype != SSB_BUSTYPE_SSB)
return 0;
- bus->irq_domain = irq_domain_add_linear(NULL, chip->ngpio,
- &irq_domain_simple_ops, chipco);
+ bus->irq_domain = irq_domain_create_linear(NULL, chip->ngpio, &irq_domain_simple_ops,
+ chipco);
if (!bus->irq_domain) {
err = -ENODEV;
goto err_irq_domain;
@@ -347,8 +347,8 @@ static int ssb_gpio_irq_extif_domain_init(struct ssb_bus *bus)
if (bus->bustype != SSB_BUSTYPE_SSB)
return 0;
- bus->irq_domain = irq_domain_add_linear(NULL, chip->ngpio,
- &irq_domain_simple_ops, extif);
+ bus->irq_domain = irq_domain_create_linear(NULL, chip->ngpio, &irq_domain_simple_ops,
+ extif);
if (!bus->irq_domain) {
err = -ENODEV;
goto err_irq_domain;
--
2.49.0
