On Tue, May 13, 2025 at 09:07:00AM +0000, Chen, Jay wrote: > From fef893bcf0add89795b85bcc1f6bdae537f1dabe Mon Sep 17 00:00:00 2001 > From: "jay.chen" <jay.chen@xxxxxxxxxxx> > Date: Tue, 13 May 2025 15:03:44 +0800 > Subject: [PATCH] usb: xhci: Set avg_trb_len = 8 for EP0 during Address Device > Command > > According to the xHCI 1.2 spec (Section 6.2.3, p.454), the Average > TRB Length (avg_trb_len) for control endpoints should be set to 8. > > Currently, during the Address Device Command, EP0's avg_trb_len remains 0, > which may cause some xHCI hardware to reject the Input Context, resulting > in device enumeration failures. In extreme cases, using a zero avg_trb_len > in calculations may lead to division-by-zero errors and unexpected system > crashes. > > This patch sets avg_trb_len to 8 for EP0 in > xhci_setup_addressable_virt_dev(), ensuring compliance with the spec > and improving compatibility across various host controller implementations. > > Link: https://bugzilla.kernel.org/show_bug.cgi?id=220033 > Signed-off-by: jay.chen <jay.chen@xxxxxxxxxxx> > --- > drivers/usb/host/xhci-mem.c | 2 ++ > 1 file changed, 2 insertions(+) > > diff --git a/drivers/usb/host/xhci-mem.c b/drivers/usb/host/xhci-mem.c > index d698095fc88d..fed9e9d1990c 100644 > --- a/drivers/usb/host/xhci-mem.c > +++ b/drivers/usb/host/xhci-mem.c > @@ -1166,6 +1166,8 @@ int xhci_setup_addressable_virt_dev(struct xhci_hcd *xhci, struct usb_device *ud > ep0_ctx->deq = cpu_to_le64(dev->eps[0].ring->first_seg->dma | > dev->eps[0].ring->cycle_state); > > + ep0_ctx->tx_info |= cpu_to_le32(EP_AVG_TRB_LENGTH(8)); > + > trace_xhci_setup_addressable_virt_device(dev); > > /* Steps 7 and 8 were done in xhci_alloc_virt_device() */ > -- > 2.43.5 Hi, This is the friendly patch-bot of Greg Kroah-Hartman. You have sent him a patch that has triggered this response. He used to manually respond to these common problems, but in order to save his sanity (he kept writing the same thing over and over, yet to different people), I was created. Hopefully you will not take offence and will fix the problem in your patch and resubmit it so that it can be accepted into the Linux kernel tree. You are receiving this message because of the following common error(s) as indicated below: - Your patch is malformed (tabs converted to spaces, linewrapped, etc.) and can not be applied. Please read the file, Documentation/process/email-clients.rst in order to fix this. - This looks like a new version of a previously submitted patch, but you did not list below the --- line any changes from the previous version. Please read the section entitled "The canonical patch format" in the kernel file, Documentation/process/submitting-patches.rst for what needs to be done here to properly describe this. If you wish to discuss this problem further, or you have questions about how to resolve this issue, please feel free to respond to this email and Greg will reply once he has dug out from the pending patches received from other developers. thanks, greg k-h's patch email bot
