Add configurations in devicetree for PCIe1, board related gpios,
PMIC regulators, etc for qcs8300-ride platform.
Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxxxxxxxx>
Signed-off-by: Ziyue Zhang <ziyue.zhang@xxxxxxxxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/qcs8300-ride.dts | 42 +++++++++++++++++++++++
1 file changed, 42 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/qcs8300-ride.dts b/arch/arm64/boot/dts/qcom/qcs8300-ride.dts
index 9d2653007866..51f299fff910 100644
--- a/arch/arm64/boot/dts/qcom/qcs8300-ride.dts
+++ b/arch/arm64/boot/dts/qcom/qcs8300-ride.dts
@@ -328,6 +328,25 @@ &pcie0_phy {
status = "okay";
};
+&pcie1 {
+ pinctrl-0 = <&pcie1_default_state>;
+ pinctrl-names = "default";
+
+ status = "okay";
+};
+
+&pcieport1 {
+ reset-gpios = <&tlmm 23 GPIO_ACTIVE_LOW>;
+ wake-gpios = <&tlmm 21 GPIO_ACTIVE_HIGH>;
+};
+
+&pcie1_phy {
+ vdda-phy-supply = <&vreg_l6a>;
+ vdda-pll-supply = <&vreg_l5a>;
+
+ status = "okay";
+};
+
&qupv3_id_0 {
status = "okay";
};
@@ -411,6 +430,29 @@ perst-pins {
bias-pull-down;
};
};
+
+ pcie1_default_state: pcie1-default-state {
+ wake-pins {
+ pins = "gpio21";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-pull-up;
+ };
+
+ clkreq-pins {
+ pins = "gpio22";
+ function = "pcie1_clkreq";
+ drive-strength = <2>;
+ bias-pull-up;
+ };
+
+ perst-pins {
+ pins = "gpio23";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-pull-down;
+ };
+ };
};
&uart7 {
--
2.43.0
