On Wed, Apr 30, 2025 at 09:16:56AM +0200, Niklas Cassel wrote: > Hello Mani, > > On Wed, Apr 30, 2025 at 12:35:18PM +0530, Manivannan Sadhasivam wrote: > > On Fri, Apr 25, 2025 at 11:20:12AM +0200, Niklas Cassel wrote: > > > While some boards designs support multiple reference clocking schemes > > > (e.g. Common Clock and SRNS), and can choose the clocking scheme using > > > e.g. a DIP switch, most boards designs only support a single clocking > > > scheme (even if the SoC might support multiple clocking schemes). > > > > > > This property is needed such that the PCI controller driver, in endpoint > > > mode, can set the proper bits, e.g. the Common Clock Configuration bit and > > > the SRIS Clocking bit, in the PCIe Link Control Register (Offset 10h). > > > (Sometimes, there are also specific bits that needs to be set in the PHY.) > > > > > > > Thanks for adding the property. I did plan to submit something similar to allow > > Qcom PCIe EP controllers to run in SRIS mode. > > > > > Some device tree bindings have already implemented vendor specific > > > properties to handle this, e.g. "nvidia,enable-ext-refclk" (Common Clock) > > > and "nvidia,enable-srns" (SRNS). However, since this property is common > > > for all PCI controllers running in endpoint mode, this really ought to be > > > a property in the common pcie-ep.yaml device tree binding. > > > > > > > We should also mark the nvidia specific properties deprecated and use this one. > > But that's for another follow up series. > > > > > Add a new ref-clk-mode property that describes the reference clocking > > > scheme used by the endpoint. (We do not add a common-clk-ssc option, since > > > we cannot know/control if the common clock provided by the host uses SSC.) > > > > > > Signed-off-by: Niklas Cassel <cassel@xxxxxxxxxx> > > > --- > > > Documentation/devicetree/bindings/pci/pci-ep.yaml | 9 +++++++++ > > > 1 file changed, 9 insertions(+) > > > > > > diff --git a/Documentation/devicetree/bindings/pci/pci-ep.yaml b/Documentation/devicetree/bindings/pci/pci-ep.yaml > > > index f75000e3093d..206c1dc2ab82 100644 > > > --- a/Documentation/devicetree/bindings/pci/pci-ep.yaml > > > +++ b/Documentation/devicetree/bindings/pci/pci-ep.yaml > > > @@ -42,6 +42,15 @@ properties: > > > default: 1 > > > maximum: 16 > > > > > > + ref-clk-mode: > > > > How about 'refclk-mode' instead of 'ref-clk-mode'? 'refclk' is the most widely > > used terminology in the bindings. > > I does seem that way. > Will use your suggestion in V2. > > > > > > > + description: Reference clocking architechture > > > + enum: > > > + - common-clk # Common Reference Clock (provided by RC side) > > > > Can we use 'common-clk-host' so that it is explicit that the clock is coming > > from the host side? > > Sure. > > I take it that you prefer 'common-clk-host' over 'common-clk-rc' ? > That's what I intended previously, but thinking more, I feel that we should stick to '-rc'i, as that's what the PCIe spec uses. - Mani -- மணிவண்ணன் சதாசிவம்
