ke 14.5.2025 klo 20.57 Niklas Cassel (cassel@xxxxxxxxxx) kirjoitti: > > Yes, but for some reason now I get different results. I wonder what's > > Now with vanilla 6.14.5 and configuration: > > sata ports 5,6 -> WDC WD5000AAKX-001CA0 > > sata ports 3,4 -> WDC WD20EFAX-68FB5N0 > > I get: ... > Well we still see: > > ATA device, with non-removable media > > Model Number: WDC WD20EFAX-68FB5N0 > > Firmware Revision: 82.00A82 > > Commands/features: > > Enabled Supported: > > * Host-initiated interface power management > > Device-initiated interface power management > > This drive supports HIPM and DIPM, > but only HIPM has been enabled. (Which does not make sense since > lpm-pol 3 includes DIPM...) > > I have no idea what is going on here... Hello Niklas! I rebooted and exactly the same configuration gives now Device-initiated interface power management on for both WD20EFAX. Also tested on 6.8.12, on which Device-initiated interface power management is off for both drives, as before. > I would add some debug prints around: > https://github.com/torvalds/linux/blob/v6.15-rc6/drivers/ata/libata-eh.c#L3512-L3520 Good idea there is something weird going on. > Did you do something with this drive? Nope. > Was this perhaps the drive that got timeout? and for some reason > the timeouts caused DIPM to get disabled? No, no timeouts. > Did you get any timeouts on the other drive of the same model (/dev/sda) ? None! Best regards, Mikko > even though it claims support for it, and you are using lpm-pol 3. > > > Kind regards, > Niklas
