Fix typos and improve wording in the bno055 driver documentation. Signed-off-by: Erick Setubal Bacurau <erick.setubal@xxxxxx> --- Documentation/iio/bno055.rst | 12 ++++++------ 1 file changed, 6 insertions(+), 6 deletions(-) diff --git a/Documentation/iio/bno055.rst b/Documentation/iio/bno055.rst index f1111ff3fe2e..c6042586b2ae 100644 --- a/Documentation/iio/bno055.rst +++ b/Documentation/iio/bno055.rst @@ -9,11 +9,11 @@ BNO055 driver This driver supports Bosch BNO055 IMUs (on both serial and I2C busses). -Accelerometer, magnetometer and gyroscope measures are always provided. +Accelerometer, magnetometer and gyroscope measurements are always available. When "fusion_enable" sysfs attribute is set to 1, orientation (both Euler angles and quaternion), linear velocity and gravity vector are also provided, but some sensor settings (e.g. low pass filtering and range) -became locked (the IMU firmware controls them). +become locked (the IMU firmware controls them). This driver supports also IIO buffers. @@ -24,14 +24,14 @@ The IMU continuously performs an autocalibration procedure if (and only if) operating in fusion mode. The magnetometer autocalibration can however be disabled by writing 0 in the sysfs in_magn_calibration_fast_enable attribute. -The driver provides access to autocalibration flags (i.e. you can known if -the IMU has successfully autocalibrated) and to the calibration data blob. +The driver provides access to autocalibration flags (i.e. you can determine +if the IMU has successfully autocalibrated) and to the calibration data blob. The user can save this blob in a firmware file (i.e. in /lib/firmware) that the driver looks for at probe time. If found, then the IMU is initialized with this calibration data. This saves the user from performing the -calibration procedure every time (which consist of moving the IMU in -various way). +calibration procedure every time (which consists of moving the IMU in +various ways). The driver looks for calibration data file using two different names: first a file whose name is suffixed with the IMU unique ID (exposed in sysfs as -- 2.43.0
