Add documentation explaining the msgid feature in netconsole.
This feature appends unique id to the userdata dictionary. The message
ID is populated from a per-target 32 bit counter which is incremented
for each message sent to the target. This allows a target to detect if
messages are dropped before reaching the target.
Signed-off-by: Gustavo Luiz Duarte <gustavold@xxxxxxxxx>
---
Documentation/networking/netconsole.rst | 32 ++++++++++++++++++++++++++++++++
1 file changed, 32 insertions(+)
diff --git a/Documentation/networking/netconsole.rst b/Documentation/networking/netconsole.rst
index a0076b542e9c..59cb9982afe6 100644
--- a/Documentation/networking/netconsole.rst
+++ b/Documentation/networking/netconsole.rst
@@ -340,6 +340,38 @@ In this example, the message was sent by CPU 42.
cpu=42 # kernel-populated value
+Message ID auto population in userdata
+--------------------------------------
+
+Within the netconsole configfs hierarchy, there is a file named `msgid_enabled`
+located in the `userdata` directory. This file controls the message ID
+auto-population feature, which assigns a numeric id to each message sent to a
+given target and appends the ID to userdata dictionary in every message sent.
+
+The message ID is generated using a per-target 32 bit counter that is
+incremented for every message sent to the target. Note that this counter will
+eventually wrap around after reaching uint32_t max value, so the message ID is
+not globally unique over time. However, it can still be used by the target to
+detect if messages were dropped before reaching the target by identifying gaps
+in the sequence of IDs.
+
+It is important to distinguish message IDs from the message <sequnum> field.
+Some kernel messages may never reach netconsole (for example, due to printk
+rate limiting). Thus, a gap in <sequnum> cannot be solely relied upon to
+indicate that a message was dropped during transmission, as it may never have
+been sent via netconsole. The message ID, on the other hand, is only assigned
+to messages that are actually transmitted via netconsole.
+
+Example::
+
+ echo "This is message #1" > /dev/kmsg
+ echo "This is message #2" > /dev/kmsg
+ 13,434,54928466,-;This is message #1
+ msgid=1
+ 13,435,54934019,-;This is message #2
+ msgid=2
+
+
Extended console:
=================
--
2.47.1
