Since the introduction of alloc_candev_mqs() and friends, there is no
longer a need to allocate a generic network device and perform explicit
CAN-specific setup. Remove the code showing this setup, and document
alloc_candev_mqs() instead.
Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
---
Dunno if this deserves
Fixes: 39549eef3587f1c1 ("can: CAN Network device driver and Netlink interface")
Documentation/networking/can.rst | 9 +++------
1 file changed, 3 insertions(+), 6 deletions(-)
diff --git a/Documentation/networking/can.rst b/Documentation/networking/can.rst
index b018ce346392652b..784dbd19b140d262 100644
--- a/Documentation/networking/can.rst
+++ b/Documentation/networking/can.rst
@@ -1106,13 +1106,10 @@ General Settings
.. code-block:: C
- dev->type = ARPHRD_CAN; /* the netdevice hardware type */
- dev->flags = IFF_NOARP; /* CAN has no arp */
+CAN network device drivers can use alloc_candev_mqs() and friends instead of
+alloc_netdev_mqs(), to automatically take care of CAN-specific setup:
- dev->mtu = CAN_MTU; /* sizeof(struct can_frame) -> Classical CAN interface */
-
- or alternative, when the controller supports CAN with flexible data rate:
- dev->mtu = CANFD_MTU; /* sizeof(struct canfd_frame) -> CAN FD interface */
+ dev = alloc_candev_mqs(...);
The struct can_frame or struct canfd_frame is the payload of each socket
buffer (skbuff) in the protocol family PF_CAN.
--
2.43.0
