Change a few words and abbreviations/punctuation.
Change one echo command to include a trailing '`'.
Signed-off-by: Randy Dunlap <rdunlap@xxxxxxxxxxxxx>
Cc: "Rafael J. Wysocki" <rafael@xxxxxxxxxx>
Cc: Viresh Kumar <viresh.kumar@xxxxxxxxxx>
Cc: linux-pm@xxxxxxxxxxxxxxx
Cc: Jonathan Corbet <corbet@xxxxxxx>
---
Documentation/admin-guide/pm/cpufreq.rst | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
--- linux-next-20250404.orig/Documentation/admin-guide/pm/cpufreq.rst
+++ linux-next-20250404/Documentation/admin-guide/pm/cpufreq.rst
@@ -231,7 +231,7 @@ are the following:
present).
The existence of the limit may be a result of some (often unintentional)
- BIOS settings, restrictions coming from a service processor or another
+ BIOS settings, restrictions coming from a service processor or other
BIOS/HW-based mechanisms.
This does not cover ACPI thermal limitations which can be discovered
@@ -258,8 +258,8 @@ are the following:
extension on ARM). If one cannot be determined, this attribute should
not be present.
- Note, that failed attempt to retrieve current frequency for a given
- CPU(s) will result in an appropriate error, i.e: EAGAIN for CPU that
+ Note that failed attempt to retrieve current frequency for a given
+ CPU(s) will result in an appropriate error, i.e.: EAGAIN for CPU that
remains idle (raised on ARM).
``cpuinfo_max_freq``
@@ -499,7 +499,7 @@ This governor exposes the following tuna
represented by it to be 1.5 times as high as the transition latency
(the default)::
- # echo `$(($(cat cpuinfo_transition_latency) * 3 / 2)) > ondemand/sampling_rate
+ # echo `$(($(cat cpuinfo_transition_latency) * 3 / 2))` > ondemand/sampling_rate
``up_threshold``
If the estimated CPU load is above this value (in percent), the governor
