the QCA_SSR_TRIGGERED and QCA_IBS_DISABLED bits cannot be cleared.
This leads to reset command timeout.
Signed-off-by: Shuai Zhang <quic_shuaz@xxxxxxxxxxx>
---
drivers/bluetooth/hci_qca.c | 12 ++++++++++++
1 file changed, 12 insertions(+)
diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
index 4e56782b0..791f8d472 100644
--- a/drivers/bluetooth/hci_qca.c
+++ b/drivers/bluetooth/hci_qca.c
@@ -1653,6 +1653,18 @@ static void qca_hw_error(struct hci_dev *hdev, u8 code)
skb_queue_purge(&qca->rx_memdump_q);
}
+ /* If the SoC always enables the bt_en pin via hardware and the driver
+ * cannot control the bt_en pin of the SoC chip, then during SSR,
+ * the QCA_SSR_TRIGGERED and QCA_IBS_DISABLED bits cannot be cleared.
+ * This leads to a reset command timeout failure.
+ * Also, add msleep delay to wait for controller to complete SSR.
+ */
+ if (!test_bit(HCI_QUIRK_NON_PERSISTENT_SETUP, &hdev->quirks)) {
+ clear_bit(QCA_SSR_TRIGGERED, &qca->flags);
+ clear_bit(QCA_IBS_DISABLED, &qca->flags);
+ msleep(50);
+ }
+
clear_bit(QCA_HW_ERROR_EVENT, &qca->flags);
}
--
2.34.1
