Changes in v8: - Rebase on 'arm64: dts: qcom: sm8450: Flatten usb controller node' - Use real name for sign-offs - Remove device tree binding patch as it's already in the tree, merged by Bjorn Changes in v7: - Document the reserved GPIO pins, remove pin 50 as it does not need to be reserved - Clarify the phone isn't limited to USB 2.0 but rather USB 3.0 isn't implemented yet - Add a newline before every 'status' node Changes in v6: - Remove debug features (bootargs, etc) that slipped in the v5 DTS - Format and organize nodes correctly based on existing DTS, move "status = "okay";" to the bottom always - Solve "ddr_device_type" and "qcom,rmtfs-mem" warnings, the rest are from existing SoC .dtsi - Disable buttons, ufs and other features for later revision Changes in v5: - Properly format the thread Changes in v4: - Try to properly format the thread Changes in v3: - Removed unnecessary initrd start and end addresses - Make sure r0q is in right order on Makefile - Properly format memory addresses - Set r0q to the correct, alphabetical order in documents Changes in v2: - Attempt to format the patchset thread correctly Eric Gonçalves (1): arm64: dts: qcom: add initial support for Samsung Galaxy S22 arch/arm64/boot/dts/qcom/Makefile | 1 + .../boot/dts/qcom/sm8450-samsung-r0q.dts | 145 ++++++++++++++++++ 2 files changed, 146 insertions(+) create mode 100644 arch/arm64/boot/dts/qcom/sm8450-samsung-r0q.dts -- 2.50.1
