Hello all,
The DWC PCIe controller driver currently does not follow the PCIe
specification with regards to the delays after link training, before
sending out configuration requests. This series fixes this.
At the same time, PATCH 1/4 addresses a regression where a Plextor
NVMe drive fails to be configured correctly. With this series, the
Plextor NVMe drive works once again.
Kind regards,
Niklas
Changes since v1:
-Put msleep() before the dev_dbg() that says "Enumerating bus" (Damien)
-Rewrite comment above LINK_WAIT_MAX_RETRIES / LINK_WAIT_SLEEP_MS (Damien)
-Remove comments above PCIE_RESET_CONFIG_DEVICE_WAIT_MS (Bjorn)
-Use different Fixes-tags (Bjorn)
-Shamelessly took Bjorn's commit message for patch 1 and 2 (Bjorn)
-Use PCIE_RESET_CONFIG_DEVICE_WAIT_MS rather than PCIE_T_RRS_READY_MS
-Add new patch (5/5) that drops PCIE_T_RRS_READY_MS
Niklas Cassel (5):
PCI: dw-rockchip: Wait PCIE_RESET_CONFIG_DEVICE_WAIT_MS after link-up
IRQ
PCI: qcom: Wait PCIE_RESET_CONFIG_DEVICE_WAIT_MS after link-up IRQ
PCI: dwc: Ensure that dw_pcie_wait_for_link() waits 100 ms after link
up
PCI: dwc: Reduce LINK_WAIT_SLEEP_MS
PCI: rockchip-host: Use macro PCIE_RESET_CONFIG_DEVICE_WAIT_MS
drivers/pci/controller/dwc/pcie-designware.c | 13 ++++++++++++-
drivers/pci/controller/dwc/pcie-designware.h | 13 +++++++++----
drivers/pci/controller/dwc/pcie-dw-rockchip.c | 1 +
drivers/pci/controller/dwc/pcie-qcom.c | 1 +
drivers/pci/controller/pcie-rockchip-host.c | 2 +-
drivers/pci/pci.h | 7 -------
6 files changed, 24 insertions(+), 13 deletions(-)
--
2.49.0
