On Sat, Jun 21, 2025 at 7:52 AM Abdelrahman Fekry <abdelrahmanfekry375@xxxxxxxxx> wrote: > > Update two sysfs show() functions in the ACPI fan driver to use sysfs_emit() > and sysfs_emit_at() instead of sprintf() and scnprintf(). > > - show_fan_speed(): replaced sprintf() with sysfs_emit(). > - show_state(): replaced scnprintf() with sysfs_emit() for the first write, > and retained sysfs_emit_at() for incremental writes. > > This change is in accordance with Documentation/filesystems/sysfs.rst, > which recommends using sysfs_emit/sysfs_emit_at in all sysfs show() > callbacks for buffer safety, clarity, and consistency. > > Signed-off-by: Abdelrahman Fekry <abdelrahmanfekry375@xxxxxxxxx> > --- > drivers/acpi/fan_attr.c | 6 +++--- > 1 file changed, 3 insertions(+), 3 deletions(-) > > diff --git a/drivers/acpi/fan_attr.c b/drivers/acpi/fan_attr.c > index 22d29ac2447c..6a53da3d6d82 100644 > --- a/drivers/acpi/fan_attr.c > +++ b/drivers/acpi/fan_attr.c > @@ -22,9 +22,9 @@ static ssize_t show_state(struct device *dev, struct device_attribute *attr, cha > int count; > > if (fps->control == 0xFFFFFFFF || fps->control > 100) > - count = scnprintf(buf, PAGE_SIZE, "not-defined:"); > + count = sysfs_emit(buf, "not-defined:"); > else > - count = scnprintf(buf, PAGE_SIZE, "%lld:", fps->control); > + count = sysfs_emit(buf, "%lld:", fps->control); > > if (fps->trip_point == 0xFFFFFFFF || fps->trip_point > 9) > count += sysfs_emit_at(buf, count, "not-defined:"); > @@ -59,7 +59,7 @@ static ssize_t show_fan_speed(struct device *dev, struct device_attribute *attr, > if (status) > return status; > > - return sprintf(buf, "%lld\n", fst.speed); > + return sysfs_emit(buf, "%lld\n", fst.speed); > } > > static ssize_t show_fine_grain_control(struct device *dev, struct device_attribute *attr, char *buf) > -- Applied as 6.17 material, thanks!