Il mer, 2002-02-13 alle 16:11, Danny Lepage ha scritto:
> You didn't say if you were using DSL / Cable modem whatever but for
Ok, I will be more esplicit:
main computer --------------- router(486dx2)----------- serial modem 56k
192.168.0.1 192.168.0.10 | dynamic
htb max 50kbit| prio
> In this case, you need to do shaping so that the traffic is queued in
> linux, not in the modem.
>
> Have a look at
> http://ds9a.nl/lartc/HOWTO//cvs/2.4routing/output/2.4routing-15.html#ss15.8 for further information.
>
I started reading the howto even before htb was programmed.
I have done an network examination where I showed how to implement
diffserv using cbq.
I then discovered that cqb was not accurate.
In new howto I discovered htb but it seems that latency goes very high.
I used script from howto. I will publish it if you ask but it seems
there is some serious problem in htb or prio. I am not alone as you can
see.
> > I have just read this message (of 2 years ago...) and I have the same
> > problem: I have a similar setup (I have used prio and htb) and when link
> > is full latency of classes with high priority raise from 200 to 2000ms.
> > In htb tutorial it show that latency of classes with prio 0 goes down.
> > Using prio does not work. Is there something missing?
> >
> > --
>
>
