On Wed, Apr 16, 2025 at 7:48 PM Paolo Galtieri <pgaltieri@xxxxxxxxx> wrote: > > Folks, > under F40 when I login after booting my system all my externally attached usb drives are mounted. Today I upgraded that system to F41 and now only a subset of the drives are mounted. Here is what I see in the log for one of the drives: > > Apr 16 16:23:47 caseyjones.homenet192-168-10.com kernel: sd 11:0:0:0: [sdk] Synchronizing SCSI cache > Apr 16 16:23:47 caseyjones.homenet192-168-10.com kernel: sd 11:0:0:0: [sdk] Synchronize Cache(10) failed: Result: hostbyte=DID_ERROR driverbyte=DRIVER_OK > Apr 16 16:23:47 caseyjones.homenet192-168-10.com systemd-homed[1657]: block device /sys/devices/pci0000:00/0000:00:1c.0/0000:01:00.0/0000:02:02.0/0000:37:00.0/usb4/4-1/4-1.4/4-1.4:1.0/host11/target11:0:0/11:0:0:0/block/sdk/sdk1 has been removed. > Apr 16 16:23:47 caseyjones.homenet192-168-10.com systemd-homed[1657]: block device /sys/devices/pci0000:00/0000:00:1c.0/0000:01:00.0/0000:02:02.0/0000:37:00.0/usb4/4-1/4-1.4/4-1.4:1.0/host11/target11:0:0/11:0:0:0/block/sdk/sdk2 has been removed. > Apr 16 16:23:47 caseyjones.homenet192-168-10.com systemd-homed[1657]: block device /sys/devices/pci0000:00/0000:00:1c.0/0000:01:00.0/0000:02:02.0/0000:37:00.0/usb4/4-1/4-1.4/4-1.4:1.0/host11/target11:0:0/11:0:0:0/block/sdk has been removed. > Apr 16 16:23:54 caseyjones.homenet192-168-10.com kernel: usb 4-1.4: new SuperSpeed USB device number 22 using xhci_hcd > Apr 16 16:23:54 caseyjones.homenet192-168-10.com kernel: usb 4-1.4: New USB device found, idVendor=0bc2, idProduct=2032, bcdDevice= 0.03 > Apr 16 16:23:54 caseyjones.homenet192-168-10.com kernel: usb 4-1.4: New USB device strings: Mfr=2, Product=3, SerialNumber=1 > Apr 16 16:23:54 caseyjones.homenet192-168-10.com kernel: usb 4-1.4: Product: Expansion HDD > Apr 16 16:23:54 caseyjones.homenet192-168-10.com kernel: usb 4-1.4: Manufacturer: Seagate > Apr 16 16:23:54 caseyjones.homenet192-168-10.com kernel: usb 4-1.4: SerialNumber: 00000000NAC6MWLH > Apr 16 16:23:54 caseyjones.homenet192-168-10.com kernel: scsi host11: uas > Apr 16 16:23:54 caseyjones.homenet192-168-10.com kernel: scsi 11:0:0:0: Direct-Access Seagate Expansion HDD 0003 PQ: 0 ANSI: 6 > Apr 16 16:23:54 caseyjones.homenet192-168-10.com kernel: sd 11:0:0:0: Attached scsi generic sg7 type 0 > Apr 16 16:24:11 caseyjones.homenet192-168-10.com kernel: sd 11:0:0:0: [sdk] Spinning up disk... > Apr 16 16:24:11 caseyjones.homenet192-168-10.com kernel: ...ready > Apr 16 16:24:11 caseyjones.homenet192-168-10.com kernel: sd 11:0:0:0: [sdk] 23437770751 512-byte logical blocks: (12.0 TB/10.9 TiB) > Apr 16 16:24:11 caseyjones.homenet192-168-10.com kernel: sd 11:0:0:0: [sdk] Write Protect is off > Apr 16 16:24:11 caseyjones.homenet192-168-10.com kernel: sd 11:0:0:0: [sdk] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA > Apr 16 16:24:11 caseyjones.homenet192-168-10.com kernel: sd 11:0:0:0: [sdk] Preferred minimum I/O size 512 bytes > Apr 16 16:24:11 caseyjones.homenet192-168-10.com kernel: sd 11:0:0:0: [sdk] Optimal transfer size 33553920 bytes > Apr 16 16:24:11 caseyjones.homenet192-168-10.com kernel: sdk: sdk1 sdk2 > Apr 16 16:24:11 caseyjones.homenet192-168-10.com kernel: sd 11:0:0:0: [sdk] Attached SCSI disk > Apr 16 16:24:11 caseyjones.homenet192-168-10.com mtp-probe[157451]: checking bus 4, device 22: "/sys/devices/pci0000:00/0000:00:1c.0/0000:01:00.0/0000:02:02.0/0000:37:00.0/usb4/4-1/4-1.4" > Apr 16 16:24:11 caseyjones.homenet192-168-10.com audit: BPF prog-id=1331 op=UNLOAD > Apr 16 16:24:11 caseyjones.homenet192-168-10.com boltd[1914]: probing: started [1000] > Apr 16 16:24:11 caseyjones.homenet192-168-10.com mtp-probe[157451]: bus: 4, device: 22 was not an MTP device > Apr 16 16:24:11 caseyjones.homenet192-168-10.com boltd[1914]: probing: timeout, done: [2985252] (2000000) > Apr 16 16:24:11 caseyjones.homenet192-168-10.com mtp-probe[157465]: checking bus 4, device 22: "/sys/devices/pci0000:00/0000:00:1c.0/0000:01:00.0/0000:02:02.0/0000:37:00.0/usb4/4-1/4-1.4" > Apr 16 16:24:11 caseyjones.homenet192-168-10.com systemd[1]: fprintd.service: Deactivated successfully. > Apr 16 16:24:11 caseyjones.homenet192-168-10.com mtp-probe[157465]: bus: 4, device: 22 was not an MTP device > Apr 16 16:24:11 caseyjones.homenet192-168-10.com boltd[1914]: probing: started [1000] > > Note that it recognized the drive, bu then it never mounted it and note the comment in bold. > > when I run lsusb I get > > Bus 004 Device 022: ID 0bc2:2032 Seagate RSS LLC Expansion HDD > > If I run fdisk -l it shows the drive > > /dev/sdk1 40 409639 409600 200M EFI System > /dev/sdk2 411648 23437768703 23437357056 10.9T Microsoft basic data > > I have not been able to figure out the options to mount the drive manually. > > Any help is appreciated. I _think_ this is happening because you are missing a udev rule for the specific storage device. The storage device is not being recognized, and it is being handled in the default case as a MTP device. See if this helps: <https://superuser.com/a/1206665>. I don't know what changed so that you have to do something special now. Maybe Todd or Samuel will remember. Jeff -- _______________________________________________ users mailing list -- users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe send an email to users-leave@xxxxxxxxxxxxxxxxxxxxxxx Fedora Code of Conduct: https://docs.fedoraproject.org/en-US/project/code-of-conduct/ List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines List Archives: https://lists.fedoraproject.org/archives/list/users@xxxxxxxxxxxxxxxxxxxxxxx Do not reply to spam, report it: https://pagure.io/fedora-infrastructure/new_issue
